SLF385 silicone 1 to 1 encapsulants are supplied as two-part liquid component kits.
When the A and B components are completely mixed, the mixture will be elastic after curing.
It is used to protect the internal components of the LED lamp. It has good thermal conductivity and is suitable for rapid construction production lines.
◆ Low viscosity, good fluidity, good protection, suitable for fast processing production lines
◆ Whit good thermal conductivity to protect electronic components
◆ Curing at normal room temperature, heating can accelerate curing
◆ UL 94 V0 certified
◆ Switch, led ballast, inverter ,adaptors
◆ Electrical component controllers and electronic sensors
◆ LED circuit board and LED lamp
◆ Other electric units product
◆ Many other uses
|Dark Gray Elastomer
|Elongation at Break
|UL94 Flame Classification
Specifications: Typical property data values should not be used as specifications.
Before mixing, Part A and Part B should be agitated well to obtain uniform elastomer. Care should be taken to minimize air entrapment.
Thoroughly mix Part A and Part B in a ratio of 1:1 by weight. The liquid mixture should have a uniform appearance. The presence of light-colored streaks of marbling indicates inadequate mixing and will result in incomplete cure. It can be automated mixing or manual mixing.
When practical, pouring/dispensing should be done under vacuum, particularly if the component being potted or encapsulated has many small voids.
Cure reaction begins with the mixing process. Initially, the mixture of Part A and Part B can be poured/dispensed directly into the container in which it is to be cured. Cure is evidenced by a gradual increase in viscosity, followed by gelation and conversion to a solid elastomer. Pot life is sensitive to environmental temperature.
Certain materials, chemicals, curing agents and plasticizers can inhibit the cure of SLF385 silicone encapsulant. Most notable of these include:
◆ Organotin and other organometallic compounds
◆ Silicone rubber containing organotin catalyst
◆ Sulfur, polysulfides, polysulfones or other sulfurcontaining materials
◆ Amines, urethanes or amine-containing materials
◆ Unsaturated hydrocarbon plasticizers
◆ Some solder flux residues
If a substrate or material is questionable with respect to potentially causinginhibition of cure, it is recommendedthat a small scale compatibility test be run to ascertain suitability in a given application. The presence of liquid or uncured product at the interface between the questionable substrate and the cured gel indicates incompatibility and inhibition of cure.
SLF385 silicone encapsulant can be selectively removed with relative ease, any repairs or changes accomplished, and the repaired area repotted in place with additional product.
SLF385 silicone 1:1 mix ratio encapsulants are available in 25kg/25kg plastic tub by set.
USABLE LIFE AND STORAGE
When stored at or below 27℃ in the original unopened containers, this product has a usable life of 9 months from the date of production.
HANDLING AND SAFETY
PRODUCT SAFETY INFORMATION REQUIRED FOR SAFE USE IS NOT INCLUDED IN THIS DOCUMENT. BEFORE HANDLING, READ PRODUCT AND MATERIAL SAFETY DATA SHEETS AND CONTAINER LABELS FOR SAFE USE, PHYSICAL AND HEALTH HAZARD INFORMATION. THE MATERIAL SAFETY DATA SHEET IS AVAILABLE FROM BAIYUN SALES APPLICATION ENGINEER, OR DISTRIBUTOR, OR BY CALLING BAIYUN CUSTOMER SERVICE.
The values in this document are not of all specifications and are subject to change without notice. As the actual situation is very different, it’s hard to guarantee the correctness and applicability of our products in some usage. Users should understand the product before using, and then decide the best way to use it.